Switch points in vacuum ranges: How are they set?

Setting the switch points of an electronic pressure switch for a credit card applicatoin in the vacuum range is not a self-explanatory task. The next article therefore explains what must be taken into account with this particular setting. It involves a pressure switch with a hysteresis function. Instruments with this configuration are most frequently installed in industrial applications.
Energetic , including the WIKA models PSD-4 and PSD-4-ECO or the A-1200 pressure sensor with IO-Link, operate as ?normally closed? or ?normally open?, depending on the task. The following graphics illustrate both switching functions with the respective switch and reset points:
In principle, the next applies: The switch point (SP) is greater than the reset point (RP) and the start of measuring range (MRS) is definitely smaller than the end of measuring range (MRE). This rule could be easily understood with settings for ambient air pressures.
Example: Control of a vacuum pump
On the other hand, setting the switch points in the vacuum range and therefore, ultimately, the switching function, requires more attention. To illustrate this, let?s take the control of vacuum pressure pump, for example, which must maintain vacuum pressure between -0.7 bar and -0.5 bar. For the task described, we decide on a pressure switch with a measuring range of -1 ? 0 bar.
The beginning of measuring range (MRS) is therefore -1 bar, the end of measuring range (MRE) 0 bar. This means: At 0 bar (= start of operation) the switch should be closed, so as to switch on the vacuum pump. If the pressure drops to -0.7 bar, the switch must open and prevent the pump. When the pressure reaches the upper limit value of -0.5 bar, the pump should once more start and run before pressure has again dropped to -0.7 bar.
ow must the switch points be set in this vacuum range? Let?s take the two pictures and translate MRS and MRE:
Here it really is clear that the ?normally open? function must be selected, otherwise the pump would not activate. After entering Selected , the schematic is obtained, which ultimately shows the way the pressure switch functions relative to the example:
Note
Information regarding WIKA?s electronic pressure switches can be found on the WIKA website. Do you want to buy pressure switches? In our WIKA online-shop you will discover a few of our standard designs. Assuming you have any questions, your contact will gladly help you.
Also read our posts
What is meant by the switching function ?hysteresis? with electronic pressure switches?
What’s the difference between the switching functions ?hysteresis? and ?window? in pressure switches?
What’s meant by the ?normally open? switching function with pressure switches?

Leave a Comment